12/11/2023 0 Comments Kasa smart plug login![]() ![]() The original technique of using the app to get it connected worked, mostly. The app says the bulb firmware version is 1.0.6. ![]() You are correct: I should have been more specific. This works like a charm and saves me plenty of time when any of the bulbs reset due to too fast power on and off cycles. The device will start connecting to the new network and if it is successful, the wifi LED will turn into green (for plugs) or fade out and in (for bulbs).The IP must be 192.168.0.1 and I had to escape all the quotation marks to make it work: Using the terminal issue the following command, replacing SSID and password second fields with the correct values.If using Windows 10, it will think twice before connecting to that wifi. Then, the device will create a open wifi AP named “TP-LINK_Smart Plug/Bulb_”. Short reset the device so it sets into connection mode (3 power on cycles for the bulbs and pressing the cog button till wifi LED turns to orange).To configure the devices, proceed as follows: This is tested with EU HS100 and HS110 and E27 LB110 and LB120. You can easily configure your TP-LINK Kasa wifi connection using the NODE-based tplink-smarthome-api ( GitHub - plasticrake/tplink-smarthome-api: TP-Link Smarthome WiFi API) cli and a computer with wifi. So I bootstrapped it with the Kasa app, and connected it to OpenHAB as described above. I know that means it can’t be used from the app, and that’s fine by me because I want OpenHab to “own” it. Since the KASA device is IP, I wanted to put it in the IOT-Internal-Only group and stop it from connecting to TP Link servers. I have one SSID on my network for IOT that can connect on the LAN but is blocked from the internet, and another that can ONLY connect to the internet. I don’t like devices “phoning home” when I don’t need to use their cloud service. You’re good to go create your items (in my case, just a switch). Just copy this correct ID back into the configuration and voila, it should connect. Save this, and after a few moments, the device will show “offline” with an error that the DeviceID you entered doesn’t match the device’s id of “correct-id-of-the-device”. You provide your desired name and the IP address, and just put some random string in the “Device ID” field. Now, in the Paper UI, (and with “TP-Link Smart Home Binding” installed) attempt to manually add the device. Now, use whatever utility you have to find the device’s IP Address. The device light will go blue to tell you it connected, but the app will say it failed (because the device can’t phone home to TP Link’s server). ![]() Go through the wizard normally, and when you get to network selection, tell the device to connect to your “internal” network. If you’re trying to configure a TP-Link device on a Wifi without internet access, here’s how.ĭownload the Kasa app to your phone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |